|
1. Follow the steps below to update your Dynamix UM-S modem firmware code
Enter in web browser "Utility"->
"System Info" or in CLI
"show" -> "system".
Further according the following information You can define the type of your device und the firmware for your device:
| MCSV |
Model |
FIRMWARE |
| 13F6-XXXX-XXXXXXXX |
DYNAMIX
UM-S |
E5110XXX.XXX |
| 13F7-XXXX-XXXXXXXX |
DYNAMIX
UM-SF |
E5111XXX.XXX |
| 145A-XXXX-XXXXXXXX |
DYNAMIX
UM-S4 |
E5210XXX.XXX |
| 145B-XXXX-XXXXXXXX |
DYNAMIX
UM-S4F |
E5211XXX.XXX |
| 1464-XXXX-XXXXXXXX |
DYNAMIX
UM-S4E |
E5220XXX.XXX |
| 1465-XXXX-XXXXXXXX |
DYNAMIX
UM-S4FE |
E5221XXX.XXX |
2. For Ordering the required firmware, you must chose it from the table below:
3. Ensure your modem is connected to the PC you will be using to upgrade.
Before continuing with the upgrade process please close all applications you may have running on your PC. Please leave the Windows Explorer window open.
4. For install Firmware, You must select in web browser "Utility" ->
"Upgrade". Chose the Firmware filename und press the button “OK”. When the update is complete, the access point automatically reboots.
More Information can you read in User Manual.
Important: After the upgrade is complete, you may need to restore your configuration settings!
WARNING: DO NOT RECYCLE POWER ON THE MODEM DURING ANY FIRMWARE UPDATE PROCESS !
MODEM MAY REQUIRE FACTORY-ONLY PROCEDURES TO RETURN IT TO OPERATION !
| 
