Configuring the Dynamix PL-E Powerline Adapter
|
1. Double click the Powerline Configuration icon shown on your desktop.
The Device tab shows the MAC address of your Powerline device connected to your computer.
If you have installed more than two Powerline devices, select the preferred one and click
Connect to access your network.
Click Refresh whenever you add or eliminate Powerline devices.
The Link Quality depends on the site’s power circuit condition, power stability, etc
2. The Network tab shows all Powerline devices present on your
network.
Click Scan Powerline Network to update Powerline network.
3. The Security tab shows the default network password is HomePlug.
Enter your own private network password if needed and click Set Local.
4. The Advanced tab allows you to add other remote device password.
You don’t need this password unless other devices set different network password with yours.
Each device password is different and listed on the bottom case label stuck on each Powerline Adapter.
Enter the device password (The format is xxxx-xxxx-xxxx-xxxx) and click Add.
Click Set All to activate the new-added password and the status column will be
shown OK.
5. Click OK to close the Utility program.
|
| |
|
